|
Product general features |
 | High precision W&M peristaltic pump for
liquid dosing and dispensing |
| 500 step through-shaft encoder, mechanically interfaced with the
peristaltic pump |
| Very low liquid pulsation |
| Suited to be used on mobile units. Inverter optionally
available. |
| New generation electronic board - 20 MHz 32 bit RISC Controller |
|
| External Hydraulics I/F |
| The system is provided with fast-connection tubing interfaces
(IN/OUT) that allow to connect the internal hydraulic circuit with an
external tank to use the MMD-0 without the internal liquid tank.
This simple solution allows to use the system for liquid metering or
liquid transfer. |
| When used without the internal tank the volume of liquid used can be
the same of the external tank. |
|
| Precision & Speed |
| better than 0,3 % over the full range [30-300] ml (sample
data) |
| ~1000 cc/min |
|
| Biocompatibility |
| Liquid circuit and wetted parts are realized
with: |
| Stainless steel AISI 316 |
| Platinum silicon tubing |
| The internal FW is able to execute clean-up cycles to allow circuit
sanitization. |
|
| Safety |
| Low & High level sensor in main (1 lt) liquid internal tank |
| No sensors when operated with the external tank |
|
| Security |
| Low Voltage power supply. |
| External double protection insulation medical grade transformer |
| Liquid internal tank is protected with a nozzle |
|
| Interfaces |
| 2 Full RS232 for interfacing the HOST PC (PC is optional in this
configuration) |
| The device can be remotely maintained when connected to an HOST-PC |
| Firmware can be remotely uploaded and relevant
parameters updated |
|
| Optionals |
| External operator Id module, using a contact-less card. |
| Specific SW application for LAB automation commands & controls |
|
|
